Kayak Fishing Adventures on Big Water’s Edge - View Single Post

coxtanker421 · 11-27-2011, 04:22 PM

i loosened bolts that retain drive locks and put some washers to shim. . helped considrably. yes i did try drives back and forth between yaks. the outback is very nice and tight. when i suspended the revo and dropped the drive in place thats when i noticed slack. i havent used yak , but i noticed slight mar on inside of drive bay from where pulley/ cable was making contact . off the record , is this yak a reject or demo model? pm if necessary. thx. i noticed all this when i was trying to set stuff up before i drill . right now yak is still a virgin. wanted to take it out tommorow .

11-27-2011, 04:22 PM	#3
coxtanker421 Senior Member Join Date: Feb 2011 Posts: 270	thx for fast response i loosened bolts that retain drive locks and put some washers to shim. . helped considrably. yes i did try drives back and forth between yaks. the outback is very nice and tight. when i suspended the revo and dropped the drive in place thats when i noticed slack. i havent used yak , but i noticed slight mar on inside of drive bay from where pulley/ cable was making contact . off the record , is this yak a reject or demo model? pm if necessary. thx. i noticed all this when i was trying to set stuff up before i drill . right now yak is still a virgin. wanted to take it out tommorow .