Mounting thr Transducer in my Yaks hull
 

I was going to get this mounting kit:

http://www.amazon.com/gp/product/B00...pf_rd_i=507846

that goes with this FF:
http://www.amazon.com/gp/product/B00...=ATVPDKIKX0DER

But according to the comments, the transducer just "sits" in "grease" in the cup? so if you were to tip your kayak, it would fall out? Im confused as to how this works. Should I buy this kit but get some other adhesive?

Look in 'innovations" there are many different ways to mount your xducer
you don't need any kits...use the force of the experience in here...

I used a pvc threaded cupling, gooped to the hull, cut a pool noodle to foam fit the transducer, fill with water then screw the cap on to keep it in place. Works great.

I mount my using electrical putty inside the hull works great no glue. Look for video on utube. U can get electrical putty home depot for $ 3.00